With the recent acquisition of an Ohm Labs HVS-50 High Voltage Standard we have expanded our high voltage measurement capabilities.
The HVS-50 is a Primary level 50kVDC/35kVAC resistive divider using precision matched resistors. The high voltage resistors are enclosed in an acrylic tube, protecting them from dust and contamination. This design is an upgrade on the HVA series of high… Read More»
With the addition of a new open jet wind tunnel we now have the capability to calibrate vane type anemometers.
The Airflow Special Products Ltd. Anemometer Calibration Rig-Open Jet Wind Tunnel is designed for the calibration of vane type anemometers. The Open Jet Wind Tunnel has a velocity range 0.25 to 30.5m/sec. (50 to 6000 ft/min.). The Open Jet Wind Tunnel consists of a centrifugal… Read More»
NVLAP Lab Code 200972-0
Essco Calibration Laboratory is pleased to announce that as of June 28, 2012 it is accredited to ISO/IEC 17025:2005 and ANSI/NCSL Z540-1-1994; Part 1 (NVLAP Code: 200972-0) by NVLAP, the National Voluntary Laboratory Accreditation Program through the United States Department of Commerce National Institute of Standards and Technology.
A copy of our… Read More»
New Gage Block Calibration Capability to 20 inches.
With the addition of the Edmunds Ultra Precision Twin Head Gage Block Comparator system we can now calibrate the full range of standard gage blocks from 0 to 20 inches. This system has been designed for high accuracy comparative measurement of gage blocks.
The twin gaging diamond contacts provide true point to point measurement,… Read More»
Using the Fluke MET/CAL® Plus Version 7.3 calibration management software we can perform fast, repeatable and powerful automated calibrations and store all parameters for every calibration test step for future reporting.
This saves us time and reduces turnaround time for you. This time saving allows us to pass on the savings to you in the form of very competitive calibration costs.
We… Read More»
Ensure your instruments
are taking accurate
measurements and can
stand up to any inspectional
or auditing process.
Fill out our
Mon - Fri
8 A.M. To 5 P.M. ET